What is in this article?:
- Solar Industry Takes a Microscopic Look at Quality to Improve Efficiency and Bring Down Costs
- ASYS & Zeta Instruments
ASYS & Zeta Instruments
In this partnership, ASYS -- a global supplier of screen printers used to apply these metal contact lines -- will begin incorporating the Zeta microscope system to obtain rapid 3D imaging of its printers' lines without contacting or damaging them in the process.
This system will help guarantee quality by detecting any fault or microscopic imperfection that may affect overall performance of a solar installation. This guarantee is essential for helping companies meet their cost effective goals, explained Vamsi Veldandla, vice president of marketing at Zeta.
|The Zeta-200 microscope system allows printers to determine the step height, roughness, dimensions, angles and volume of solar cells.|
"The entire efficiency of the panel is limited by the weakest link," he said. "If one vapor is out of spec ... then it restricts the entire module. So people have started putting in more production and quality control checks."
"If a company like ASYS wants to supply equipment to the industry, their equipment has to meet certain specs, even before it is installed." With Zeta monitoring quality, he said, "ASYS is qualified to create a certain contact line geometry based on the results. That gives them an edge on their competition who cannot prove the quality of their contact line printing process."
Stakes in this department are higher than anywhere else in the manufacturing process, Veldandla said. Saving money on contact lines and proving efficiency can translate into significant costs savings.
"The contact lines are made of metal and some of them are really expensive," he said. "Almost 40% of the cost [of a solar cell] might be going into these metals."
To fight these costs, manufacturers thin their lines out as much as possible, just as they have with the cells. However, this creates a difficult balance to maintain.
"You don't want the contact line to be too thick, because it's a waste of metal," said Veldandla. "But you don't want it to be too thin either because then sometimes you get shorts or breaks in the line."
To resolve this, he said, more companies are turning to equipment suppliers like Zeta to help guarantee quality all across the product.
"We did a study with applied materials and we found there is a certain optimum set of parameters which give you the best texture when etching the vapors," he said. By using its system to verify specs, he said, companies can now "focus on creating better lines, better contacts, cleaner lines. Control the measurement of printing better. That's why people are buying equipment like ours, which is helping them improve their profits."